The machine is already in operation, the X-axis end limit switch cable was damaged
Thanks for the help
Mariusz
Search found 5 matches
- Mon Jun 18, 2018 7:31 pm
- Forum: Thunder Laser Tech support
- Topic: X-axis does not work
- Replies: 5
- Views: 16982
- Sat Jun 16, 2018 6:19 am
- Forum: Thunder Laser Tech support
- Topic: X-axis does not work
- Replies: 5
- Views: 16982
Re: X-axis does not work
Hi Ben,
Laser head can reset to top left corner when turn on the machine and then there is an error on the driver -
green LED is on and the red one is blinks
Mariusz
Laser head can reset to top left corner when turn on the machine and then there is an error on the driver -
green LED is on and the red one is blinks
Mariusz
- Wed Jun 13, 2018 9:02 pm
- Forum: Thunder Laser Tech support
- Topic: X-axis does not work
- Replies: 5
- Views: 16982
X-axis does not work
Hello, I have Nova24 - Laser System and the problem is with X-Axis -it does not work. I checked the X-axis controller - the controller is switched on, the green LED is on and the red one blinks. I installed the controller with Y-axis and there is still the same problem (green LED is on and the red o...
- Mon Mar 19, 2018 10:04 am
- Forum: Thunder Laser Tech support
- Topic: Nova24 engraving problem on X-Axis
- Replies: 3
- Views: 5095
Re: Nova24 engraving problem on X-Axis
Hi Jason
Yes, engraving on Y axis is good quality.
Focus lens is clean .
Which X axis drive belt should I check and how to tension it?
Can you send the instructions?
Yes, engraving on Y axis is good quality.
Focus lens is clean .
Which X axis drive belt should I check and how to tension it?
Can you send the instructions?
- Thu Mar 15, 2018 10:00 pm
- Forum: Thunder Laser Tech support
- Topic: Nova24 engraving problem on X-Axis
- Replies: 3
- Views: 5095
Nova24 engraving problem on X-Axis
Hello I have a problem with engraving on X-axis - laser Nova24 60 Watt Engraving is very low quality (please see photos in the attachment) 1.jpg 2.jpg 3.jpg For engraving we use the following settings: Scan mode, 400 mm/s speed, 15 power and interval 0,08mm. This problem occurs on each material. But...