Search found 6 matches

by laserbell
Thu Apr 12, 2018 5:58 am
Forum: General Laser machine discussion
Topic: Laser Beam Pattern
Replies: 5
Views: 1959

Re: Laser Beam Pattern

If you determined that the laser failed prior to the end of the warranty period, then you can take a video and send it to RECI. You can examine the electrodes on the ends for discoloration (that typically happens when the power supply is adjusted too high, and voids your warranty). If you want to se...
by laserbell
Thu Apr 12, 2018 5:48 am
Forum: General Laser machine discussion
Topic: Laser Beam Pattern
Replies: 5
Views: 1959

Re: Laser Beam Pattern

Contact RECI laser directly and ask them the question, showing them your results. I ran into a similar problem and had the same unusual mode, then contacted RECI. They told me that when the internal gas is consumed, then you will see an unusual raw beam pattern like you show, rather than the cone/ga...
by laserbell
Thu Apr 12, 2018 5:41 am
Forum: General Laser machine discussion
Topic: Laser won't fire when controller is connected to controller?
Replies: 1
Views: 1104

Re: Laser won't fire when controller is connected to controller?

Typically, the water chiller circuit switch is defeated by jumpering the CO2 laser power supply. In other words, the water flow or chiller safety switch closes a circuit at the laser power supply itself. Some power supplies differ, but you can google search the laser power supply wiring diagram and ...
by laserbell
Tue Apr 03, 2018 8:10 am
Forum: General Laser machine discussion
Topic: VERY FRUSTRATED with laser!
Replies: 1
Views: 2508

Re: VERY FRUSTRATED with laser!

Examine the control card to see the LED sequence, as that provides error codes.
by laserbell
Tue Apr 03, 2018 8:08 am
Forum: Laser cut designs
Topic: Anyone use stylecnc fiber laser cutting machine ST-FC3015?
Replies: 2
Views: 1063

Re: Anyone use stylecnc fiber laser cutting machine ST-FC3015?

My experience is with Weike laser and they do a good job. I visited them and purchased dozens of laser machines from them and they are very good at support and help and making improvements if necessary.
by laserbell
Tue Apr 03, 2018 8:07 am
Forum: Laser Knowledge
Topic: Chinese laser y-axis problem after rotary use
Replies: 2
Views: 945

Re: Chinese laser y-axis problem after rotary use

Try re-seating the cable, then power down. When power is off, try moving the gantry back and forth to make sure that there is no obstruction, like some cable holding it back from proper motion. Then power on and home. If it does not home properly, perhaps the cause is that the firmware got corrupted...