Search found 3 matches
- Sat Feb 24, 2024 2:11 pm
- Forum: General Laser machine discussion
- Topic: Newbie having some issues
- Replies: 6
- Views: 1609
Re: Newbie having some issues
I did some testing with my MM, swapped the stepper motor drivers, swapped the motor cables, no change to the issue. I'm not sure if or how I can upgrade the FW on the Laseraxe board or if that is even the cause. It seems like the X axis stepper motor is having power applied to both directions so it ...
- Fri Feb 23, 2024 1:26 am
- Forum: General Laser machine discussion
- Topic: Newbie having some issues
- Replies: 6
- Views: 1609
Re: Newbie having some issues
I was able to successfully flash the Arduino Nano with GRBL [VER:1.1h.20190830:] using Arduino IDE. I can communicate with the Nano and attached a screenshot of the current settings and version. I'm going to start looking at the Laseraxe CNCC Mini control board now. There may be something funky goin...
- Thu Feb 22, 2024 3:02 am
- Forum: General Laser machine discussion
- Topic: Newbie having some issues
- Replies: 6
- Views: 1609
Newbie having some issues
Hello, New to the forum and to laser engraving overall. I got my hands on a free 2 axis laser engraving setup that was getting tossed. It was working fine and I have done quite a few things on it so far with no issues. I was working on a project the other day and after a job finished the setup no lo...