Laser Engraver Forum

friend! I haven't encountered this kind of situation. Which laser cutting machine do you use, is there a high probability of such a thing happening? I have been using China's Thunder laser cutting machine. It seems that my choice is correct!I used to see the FAQ module on their official website. I ...

God, I just came across this problem ,like this: I will use your method to rule out, if it is useful, I will come back to thank you.

hi what are your min power settings on the laser, there are setting on the controller for max and min power, also in the software fior corner power ( or min power) this is the power it uses when doing curves, on engraving what is your step values for engraving..ie 0.05mm step if its cutting but not...

does the laser behave erratically when its on the way out ? I'd really appreciate some some expert opinion here as I'm just about to order a new tube and lens and would like to make sure if these are really necessary What I find really strange is that it burns more powerfully when doing circles to t...

Yes,I think so to, I only find it strange that for cutting power is still the same more or less and I don't cut with full power, I always try to use the least power and is it instant when it happens, I had the idea it would be gradual not ok one minute and the next is bad, I am thinking of buying th...

Hello！I have an 80w chinese laser machine， I am trying to engrave a drawing but its not doing it properly, on vertical lines it goes deep but doing letters its very weak and letters turn out much lighter I also tried to vector engrave a drawing in cutting mode with low power and it was going well un...

Hello！
In my opinion ，the problems is lasertube！
when did you buy the machine?

Hi, right now, in my machine (golden laser), the propietary software dont let me change frecuency I am waiting a new control that i bought in china (ruida rdsc6442s) that allow me to change a lot more. You are not talking about pwm to control power supply, you are talking about flecuency of pulsed l...

Hi job,
Well done.
I'm trying to be an another.Waiting for my good news.
RichardKI

Hello All,
In todays article Id like to share with you A laser cut mechanical toy based off a planetary gear system. I hope you enjoy them, too.
File: