Search found 8 matches
- Fri Feb 12, 2021 2:31 am
- Forum: General Laser machine discussion
- Topic: MARS 130 Power down
- Replies: 2
- Views: 1734
Re: MARS 130 Power down
Ok never mind, I traced the power to the emergency stop button, someone had accidentally pushed it. Problem solved.
- Fri Feb 12, 2021 2:01 am
- Forum: General Laser machine discussion
- Topic: MARS 130 Power down
- Replies: 2
- Views: 1734
MARS 130 Power down
Hi Thunder Laser, my Mars130 laser machine won't turn on this morning. I checked the fuse is fine, the power is coming into the machine through the AC plug, however I can't get an AC power reading at the "Main Switch" on L1 & N1. Do the L1 & N1 cables divert anywhere before reachin...
- Thu Jun 21, 2018 2:52 am
- Forum: General Laser machine discussion
- Topic: Control Mars 130 via network cable & switch
- Replies: 3
- Views: 1613
Re: Control Mars 130 via network cable & switch
Thanks so much Ben that's perfect. The Gateway setting on the machine was still on the default 255.255.255.0. Everything works perfectly now.
- Tue Jun 12, 2018 5:13 am
- Forum: General Laser machine discussion
- Topic: Control Mars 130 via network cable & switch
- Replies: 3
- Views: 1613
Control Mars 130 via network cable & switch
Our workshop computers are all connected to the internet via network cable. We also control our Mars 130 via network cable.
Is there any possibility to communicate with the Mars 130 via a switch such as this one: https://www.netgear.com/support/product/GS605.aspx
Is there any possibility to communicate with the Mars 130 via a switch such as this one: https://www.netgear.com/support/product/GS605.aspx
- Mon May 28, 2018 2:59 am
- Forum: General Laser machine discussion
- Topic: Machine Protected, Work Paused
- Replies: 1
- Views: 4510
Re: Machine Protected, Work Paused
I've done some more testing and I think the lid open sensor may be dead, tried triggering it with a magnet but no response. Any possibility to replace it?
- Mon May 28, 2018 2:40 am
- Forum: General Laser machine discussion
- Topic: Machine Protected, Work Paused
- Replies: 1
- Views: 4510
Machine Protected, Work Paused
I've been using my Mars-130 for a few years now with no issues, however a new problem popped up last week and I can't figure out the cause. When starting a new job using RD Works, the machine air protect comes on as usual but the machine won't start the job, beeping then reading "Machine Protec...
- Wed Oct 12, 2016 6:44 am
- Forum: General Laser machine discussion
- Topic: Laser power down after mirror cleaning
- Replies: 3
- Views: 1848
Re: Laser power down after mirror cleaning
Hi and thanks for your reply. The concave side of the lens is facing downwards as recommended by the manufacturer.
- Wed Oct 12, 2016 2:01 am
- Forum: General Laser machine discussion
- Topic: Laser power down after mirror cleaning
- Replies: 3
- Views: 1848
Laser power down after mirror cleaning
Hi Laser Forum, I have a MARS-130 100W purchased from Thunder Laser in October 2015. So far the machine has been great, however after a particularly messy job I decided to remove the mirrors and give them a clean. This is the first time I'd had a go at removing and cleaning the mirrors. After reinst...