Laser Engraver Forum

Hi Steven, It seems that the laser tube have loss of power. The ammeter have reading of 23,so the laser power supply should be fine. If the laser tube have lost power so much as you said,i'm afraid it became bad now. To check the laser tube,please check the Beam pattern of laser tube by laser a dot ...

Hi Mariusz,

OK,the laser hear can reset to top left corner,so the connection for motor and driver should be fine.
So if the laser head can normally touch the X axis limit switch,or hit the limit switch and stop then do not move anymore.

Hi Mariusz,

Sorry for your problem.
About your problem,X-axis does not work,i'm wondering if the laser head can reset to top left corner when turn on the machine,or just Y axis work well.

Hi Steven,

As you said,it's more likely about the controller or software issue.
Please send me the test files for checking.Thanks.

Hi Steven, It seems that controller is not working well. Maybe the memory of controller is full,please clean up the files. Or you can just format the memory as following. On LCD panel>>File>>Other+>>format the memory speedily. After that,let me know if that problem is resolved or not.

Hi Idan, If there's a lot of loss for the laser power，it's more about the problem from focus lens or laser beam path. Please check them for sure,the focus lens is intact and clean and the laser beam goes down vertically to four corner of table. If they are just fine,so it seems that the power of las...

Hi Idan,

We buy the eye potection glasses on Taobao instead of Amazon.
You can refer to the link below.
https://www.cnczone.com/forums/general- ... laser.html

Hi Idan, Sorry for my late reply. For your cutting problem,sometimes it cut through just fine and other times it won't. It seems that the setting is at the threshold between cut through or not. We suggest to lower the speed a little bit just fine. Besides,you should know that the MDF is more difficu...

Please install the RDworksV8.19.
It has setting for reverse interval and good to X-swing engraving.
http://www.thunderlaser.com/download/down/RDWorksV8.rar

Generally,it's left top corner.