Laser Engraver Forum

the other pic

Hi Ben. Low left corner Attached is the image that shows that the laser head goes beyond the low left corner of the flatbed. it goes to the metalic edge, does not stop where the honey comb ends. Top left corner On the other side, you can see on the second picture where are the burn marks on the hone...

Hello Ben I have identified at least 3 big problems with the machine. #1. There is no red dot pointer, it has never worked. I have attached pic to see that I cannot see any red dot pointer on the material that I am trying to cut. (pic red_dot_pointer.jpg) #2. The XY axis - the head does not go to th...

Hi

The red dot pointer is supposed to be a standard feature. It has never worked. What should I do to enable it?
Thank you
Anda

Hi Ben, I have to cut a cardboard only half of its thickness and I was playing around and get very good results using the pulse button. In few passes the cardboard was half cut and the cuts were extremely clean, no trace of burn at all. # Is it OK to use the pulse function for this type of job? ( I ...

The Outstanding air compressor that came with the nova 63 machine a capacity of 60 liters /min and we need to purchase an electro valve. What should be the characteristics of the electro valve to accommodate efficiently the new air pump? The valve that we have already purchased is not good (1/4"...

Hi Ben,

Which software do you suggest?

Does the double line have any impact on the time need to cut the design?

Thank you
Anda

Hi Ben I was observing the laser and when the file has double lines it fires twice the same path and it takes longer to cut the pattern. If instead of a double line is a single line the time to cut the same patter is less. Centreline is a middle line between the two lines and it replaces these lines...

I trace the image in inkscape. Tx.

Hi

When I trace an image a double line is formed. What tool should I use to centerline ? Does the double line affect in any way the path of the laser beam?
Thank you