Laser Engraver Forum

Hi Peter, your problem should be caused by the table that it wasn't level both sides. First Checking. 31.jpg Ok, let's us to fix it out You know, the table was controlled by two motor under the table, you should looked them before And the reason as you said that the motors are a little out of sync P...

Hi Peter, your computer can not communicate with the machine,right? Okay, it should be a driver issue. i think that you did not installed the driver finished for your pc So the software still does not recognize the machine. I believe that you should tried installing the driver for pc using automatic...

From your picture, the laser beam size is big, can you please try to cut 10mm acrylic with 70% power, and tell us what is the highest speed?

Hi,
You can search "Keylock Selector Select Switch" on Amazon or Ebay,such as
https://www.amazon.com/dp/B009IPEB8A
https://www.amazon.com/dp/B008ZY9CXE
However ,our Thunderlaser machine to improve the reliability of machine safety, the plane has dual key lock and electrical safety

Hi Peter, 1. As you purchased the laser about 4~5 years ago, the software should be lasergrave. As we use another controller and software, but you still can download lasergrave from this link. http://www.thunderlaser.com/download/down/LaserGRAV_V8.98.exe 2. Not sure your laser is good or not, you do...

Hi Sir or Madam, I am yumiko from thunderlaser,may I know how thick for your poly carbonate are you going to cut? and may I know where are you from? for poly carbonate,engraving by laser machine is no problem,however,cutting is not good. As we have client from Australia by our machine do this materi...

Hi!
Thanks for your video.
First of all, I need to check the vendor setting of your laser.
please kindly find attached picture and show me picture as it shown.

Hi David, If the dxf file i sent to you can run by PHCAD. 1、why The PHCAD software does not recognise a simple .ai file produced from a commercial version of Adobe Illustrator even though it says it can. The PHCAD have not optimized since 2013,so lead to it can not support high version of ai file we...

Hi David, I had tried the file you attached,and all files except .dxf file have error. Maybe you did not convert this file in correct way. I have had tried to convert the file as .dxf file and it can be imported by PHCAD. What type the file save as,please see the attached picture. and also send the ...

Hi Jasper_Rullman
Thanks for you suggested.
it will help us to improve our software.
Hoping you everything is well.