Hi All, I just received my 2500 mw Banggood Laser Engraver and cannot seem to get the software installed on the machine.
So far all I can get is the blue dot to come on and focus the beam. The rest of the controls are not responding.
The instructions say to use Com 1 and load the Nano software but that does not work.
Is there anyone with experience installing Benbox software on this type of DIY laser engraver?
Thanks,
Peter
Benbox software installation
Moderator: baker
-
- Posts: 3
- Joined: Fri May 15, 2015 3:17 am
Re: Benbox software installation
Hello Peter!
oh!It was so coincidental !beacuse i also bought the same machine ,yestoday!
oh!It was so coincidental !beacuse i also bought the same machine ,yestoday!