Page 1 of 1

New Thunderlaser unable to set power above 70% why?

Posted: Mon Mar 13, 2017 3:19 pm
by st7
Image

Brand new Nova63 130 watt.

Any ideas?

Re: New Thunderlaser unable to set power above 70% why?

Posted: Tue Mar 14, 2017 6:14 am
by Thunder Laser -Nolan
Hi.
you can change the setting on RDWorks.
Ventor setting-ventor parameter password-rd8888
My colleague Ben will send details to your email soon.

Re: New Thunderlaser unable to set power above 70% why?

Posted: Tue Mar 14, 2017 1:58 pm
by st7
Thank you for the help.

Re: New Thunderlaser unable to set power above 70% why?

Posted: Sun May 13, 2018 7:56 pm
by jimcolton
Personally, I would recommend you set the max power to 40 or 50% if you don't want to be replacing your tube every 1000 hours.

Laser tubes are often rated for maximum output. Otherwise, they are rated for about 75-90% output. Running a glass tube at high output makes the output power curve degrade quickly enough that you have to recalibrate your work speeds and reduces your typical output quality because of power curve decay.

A RECI or EFR tube rated for 7,000 hours or 10,000 hours is really going to treat you better if run below 50% for cutting and below 30% for everything else.

Positioning gears and motors will only be put through half the stress and strain if run at 70% of maximum speed. at 50% speed they only experience about 25% of the abuse of full speed operation.

Get more power and table size than you need and run the machine conservatively and it will treat you better.

Just my 2 cents.