K40 and CorelLaser parameters

Discuss laser machine here freely.

Moderator: baker

Post Reply
TimM
Posts: 6
Joined: Thu May 11, 2017 9:36 pm

K40 and CorelLaser parameters

Post by TimM »

I've got my K40 laser and associated software running, and had success at simple engraving tasks. But it is frustrating that the 'hardware setup' screen, as well as the Corel Laser 'Start burning' screen have a zillion parameters that are undocumented as far as I can tell. Between the names of various parameters, and much experimentation on my part, I've figured out enough of them to get things to work. But that's a tiny fraction of everything there. Does documentation exist anywhere? Has anyone here figured out many or most of them?

I'll make a deal. If one or more people here post correct sounding explanations for most of these parameters, I'll write up organized documentation and post it for use by others. This would be so nice to have.

Tim
Post Reply