Welcome to laserengraverforum.com!

New Thunder laser Nova24-60W

Discuss laser machine here freely.

Moderator: baker

Posts: 1
Joined: Fri Jun 09, 2017 1:47 pm

Re: New Thunder laser Nova24-60W

Postby d-laser » Fri Jun 09, 2017 1:50 pm

Hi gene

I think you pushed to grab one after 1 year of research I am glad to hear your story had a positive outcome.

hopefully all is still going smoothly.

is there an air filter option for this machine for indoor use?

Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: New Thunder laser Nova24-60W

Postby Thunder Laser -Nolan » Mon Jun 12, 2017 3:54 am

Yes, we have an air filter option for indoor use.

Posts: 3
Joined: Mon Jul 10, 2017 7:24 am

Re: New Thunder laser Nova24-60W

Postby rithkhmer » Mon Jul 10, 2017 7:27 am

thank for good topic and great.....

gclub casino


Posts: 2
Joined: Mon Aug 07, 2017 12:18 pm

Re: New Thunder laser Nova24-60W

Postby sowparnikaks » Mon Aug 07, 2017 12:27 pm

One more thing Nova24 was sold as a 60 watt laser tube but what I have found out from the factory tech, it is only putting out 40 watts of power. He said to check the X axes limit switch and wiring. I had already checked these but what hell check everything again. Now this morning the X axes will not reset at all! And the Nova24 will not run a program file like it should. The Y axes will run but not the X axes. Funny thing is if I use the arrow to jog the X axes the control panel shows the axes is moving. I have looked at everything I can think of to look at, limit switch, wiring, controllers. The diagnosis screen "red box" shows the X limit switch is functioning as it should.Then it started acting strange. Sometimes when I would turn the power on the X & Y would reset, like normal, but the next time I would use the machine and power up, the X axes would not reset and the X would not move at all. Y axes works fine. As a couple of days went by this problem has gotten worse. I sent an email the the factory tech. I just bought this Nova24-60W two weeks ago and I am already so frustrated with it I could take a BIG hammer to it :oops:
When I first brought it home it worked just fine.

best business schools in the Bangalore
best business schools in the India
best business schools

Return to “General Laser machine discussion”

Who is online

Users browsing this forum: No registered users and 5 guests