Thunder Laser Mars 90 Y axis stuck
Posted: Sun Jul 16, 2017 10:33 pm
After I plugged in the wrong rotary, My "Y" Axis is stuck. It still moves with the controlles but only about 5 inches or so. When I look at the controller its reading that its reached the table limit of 600mm, but its no where close to where the 600 should be reading. Its a MARS 90 900x600. It seems the controller thinks that its in end position for the Y axis, but its not.
I tried to reset it several times and I did not see any red lights on for the drivers. Also, Yes the Rotary switch is off.
Thanks
RR
I tried to reset it several times and I did not see any red lights on for the drivers. Also, Yes the Rotary switch is off.
Thanks
RR