Page 1 of 1

Laser Etching Aluminium

Posted: Fri Aug 11, 2017 2:55 pm
by Pfuller9
I have a lot of Aluminium Composite panels, which were for a project that didn't come off. I'd like to use these panels for laser marking/etching. The panels are two outer layers of painted aluminium, with an inner layer of polycarbonate. The total thickness of the panel is 3mm.
As the panels are already painted will I still need to spray on a product such as Cermark?

Thanks

Re: Laser Etching Aluminium

Posted: Tue Oct 24, 2017 12:57 am
by To The Point Laser
It will engrave just fine with the coating you have