Welcome to laserengraverforum.com!

Laser Etching Aluminium

Discuss laser machine here freely.

Moderator: baker

Pfuller9
Posts: 4
Joined: Sat Jun 03, 2017 4:51 pm

Laser Etching Aluminium

Postby Pfuller9 » Fri Aug 11, 2017 2:55 pm

I have a lot of Aluminium Composite panels, which were for a project that didn't come off. I'd like to use these panels for laser marking/etching. The panels are two outer layers of painted aluminium, with an inner layer of polycarbonate. The total thickness of the panel is 3mm.
As the panels are already painted will I still need to spray on a product such as Cermark?

Thanks

Return to “General Laser machine discussion”

Who is online

Users browsing this forum: No registered users and 2 guests