xy on laser 10000

Discuss laser machine here freely.

Moderator: baker

Post Reply
BridgettMunn
Posts: 3
Joined: Thu Aug 31, 2017 4:50 pm

xy on laser 10000

Post by BridgettMunn » Thu Aug 31, 2017 5:05 pm

just signed in to this forum. have a red black Chinese laser with rdworks software. problem is my laser par. are stuck at 10000x x 10000y so on power up machine wants to go forever and will slam wall. I can stop it with esc key but am afraid to run laser as don't know if it will mess up and hit wall if I am not standing right there with had on emg. stop. I cant find where to change this. went to vendor setting didn't see anywhere that said it is set to 10000mm. but also I have a problem with the usb port not commuciating with laser. any help would be great Bridgett
bed should be x 700mm and y 500mm

User avatar
LINUS
Webmaster
Posts: 232
Joined: Tue Apr 28, 2015 3:55 am

Re: xy on laser 10000

Post by LINUS » Fri Sep 01, 2017 2:22 am

vendor setting.Look the pic.But you need vendor pwd
lcj-09-011.jpg
lcj-09-011.jpg (46.44 KiB) Viewed 3230 times
breadth.png
breadth.png (22.54 KiB) Viewed 3230 times
Because of major,be at ease so.

BridgettMunn
Posts: 3
Joined: Thu Aug 31, 2017 4:50 pm

Re: xy on laser 10000

Post by BridgettMunn » Thu Sep 07, 2017 2:30 am

thanks for the reply I have tried resetting at this point. it did not work should I reinstall the software on the cpu and try it again.

cargom
Posts: 6
Joined: Thu Apr 19, 2018 7:56 am

Re: xy on laser 10000

Post by cargom » Thu Apr 19, 2018 10:28 am

Hi

did you find the awnser to the X Y reading 10000mm

Ben
Posts: 101
Joined: Tue May 24, 2016 9:06 am

Re: xy on laser 10000

Post by Ben » Fri Apr 20, 2018 2:23 am

The coordinate of X and Y show you as 10000*10000.
I wonder if the laser head cannot be resetting well.
Please check the limit switch on the parking position.

Post Reply