Hi folks.
Before I go headlong into the cutting issues, I thought it might serve me well to give you a bit of background.
I recently had quite a bad accident and find myself home alone, with one leg and a wheelchair, and due to medication extremely diminished cognitive ability compare to my prior two legged self!
I have for a while done some hand cutting with a blade,many someone suggested a cheap Chinese laser cutter could perform this easily for me.
(I only want to cut through paper/card, outlines and don't have any inclination to do fancy carvings)
I bought, after checking feedback and reviews, an A3 500mw cutter from eBay that came with the Benbox software.
After updating the firmware and a bit if jiggery the laser turns on and work and the software talks to the laser.
All good.
So I want to cut an outline, and I have played with the speed/time settings and had these right down to 50 each and I now get an outline, but it is burned into the paper rather than cutting.
Apologies, I know my terminology is not correct.
How can I cut paper, I am sure it is something to do with the laser alignment and the time/speed settings, but am unsure as the focusing wheel is wobbly/loose
Does any very patient individual have the time or inclination to go through settings with me so this thing works?
Thanks in advance.
Kelly X
Hello and help!
Moderator: baker
Re: Hello and help!
you should try use slowly speed and Higher power.Such as 40mm/s and 70% power
-
- Posts: 8
- Joined: Mon Oct 23, 2017 11:48 pm
Re: Hello and help!
I will try to help you but you will need to add more information about your laser, is it CO2 ? What is the size and power of the tube, what size lens are you using ? Paper should cut very nice and clean with no burn marks, from the little information you posted I would start with a basic answer of not a good size lens or bad focus. I suggest the largest dot size lens for paper should be 50.8mm for a nice cut.
If you are using a 80-100 watt laser you should be running at about 15% power and 50 speed.
For your information I am in the same health situation as you however I have 15 years experience with laser machines.
If you are using a 80-100 watt laser you should be running at about 15% power and 50 speed.
For your information I am in the same health situation as you however I have 15 years experience with laser machines.