X slop and Frame drawing to small

Discuss laser machine here freely.

Moderator: baker

Post Reply
kecka86
Posts: 2
Joined: Thu Oct 26, 2017 2:04 pm

X slop and Frame drawing to small

Post by kecka86 »

Hi i have read through a few posts and cant figure out how to fix this problem. My machine says Xslop when i send something to the machine which i figured out meant i was trying to draw outside the frame. One forum said press origin (this did nothing) i then pressed frame as i knew the item i was cutting was only 10m by 10cm and my machine is 50 x 30. But when i pressed frame it only drew a small frame in the top corner of the machine but it used to draw the full 50 x 30 frame. Can anyone tell me how to get my full frame size back? I have done the origin, set factory parameters, set default parameters and also checked the x and y in vendor settings and they still say 500 and 300.
Thanks
kecka86
Posts: 2
Joined: Thu Oct 26, 2017 2:04 pm

Re: X slop and Frame drawing to small

Post by kecka86 »

Has anyone heard of this before? Have a few orders waiting to go out and just wanted to find out if it can be fixed before cancelling orders :(
Post Reply