Welcome to laserengraverforum.com!

Laser Engraving Ring cutout

Discuss laser machine here freely.

Moderator: baker

Post Reply
Posts: 2
Joined: Tue Nov 07, 2017 6:06 am

Laser Engraving Ring cutout

Post by jensenbreck » Tue Nov 14, 2017 2:32 pm


I am trying to laser engrave a cutout into a trophy base to glue a bowl into I need to laser a ring 2.1" thick with 4.9" diameter in center of line. I ran the job as a raster job in my 75 watt Legend 32 EX CO2 (My most powerful machine). It looked like it will work, but it too 15 minutes to do it. Is there any other way for me to engrave this that won't take as long. Ie. Can I run it as a few vector cutting jobs to achieve the same depressed ring. I also thought of chopping the circle in half and running one half at a time. If anyone has any ideas, please let me know.

I didn't find the right solution from the internet.

http://www.sawmillcreek.org/showthread. ... ing-cutout

2d animation

Posts: 2
Joined: Wed Nov 22, 2017 7:12 pm
Location: USA

Laser Engraving Ring cutout

Post by tevaitiart » Fri Nov 24, 2017 4:52 pm

Not sure if you know but Laser Jammers are Illegal in Illinois. Shhhhh... I won't tell that you have one
The whole truth about a vehicle’s history on a blockchain. www.twitter.com/VINChain_io

Post Reply