Page 1 of 1

Vector cutting circle or round shapes problem

Posted: Tue May 15, 2018 6:11 pm
by STL_KR10
When cutting any vector circles I'm getting the following marks. How do I fix this? Laser is aligned, stepper calibrated. This is on every cut.
20180514_192854.jpg
20180514_192854.jpg (77.73 KiB) Viewed 1864 times

Re: Vector cutting circle or round shapes problem

Posted: Fri May 18, 2018 10:26 am
by matthewwilson
Very good post. Lots of information mentioned in this article. Thanks for sharing here.

Property management in Crofton MD