Laser Marking Machine Maintenance Tips

Discuss laser machine here freely.

Moderator: baker

Post Reply
lasercuting
Posts: 24
Joined: Fri Jul 13, 2018 6:25 am

Laser Marking Machine Maintenance Tips

Post by lasercuting »

1.Keep the machine clean: both the the surface and inside of the machine.
2.Check whether the red light preview can be turned on normally: set the laser parameters in the specified range, and turn on the red light correction on the software to test.
3.Check if the laser's cooling water is dirty: the laser cooling water circulating tank must be frequently changed to pure water.
4. Clean the refractor: first use a special lens paper to wipe it with alcohol in one direction, and wipe it with a dry lens paper.
5. Check whether the laser light is normal: open the software manual laser switch to turn on the laser.
6.Clean the inside of dust, dirt and foreign matter: with a vacuum cleaner, alcohol and clean cloth to remove dust, dirt and foreign matter.
7.Check that the focal length is within the standard range: test if the laser reaches the strongest state.
8. Check whether the galvanometer is dirty: wipe with the mirror wiping paper.
9. Check whether the laser parameter setting is normal: if the laser parameters are within the setting range.
10. Whether the machine is normally open: check the machine power, laser and operating software switch.
11.Check if the chiller coolant is above the alarm line: if it drop to the alarm line, you should add coolant in time.
12.Make sure the emergency switch is working properly: after pressing the emergency switch, check if the servo is powered on.
13. Check whether there are laser protective glasses on the production marking equipment and whether it is worn as required during the work.
Attachments
Perfect Laser-Fiber Laser Marking Machine
Perfect Laser-Fiber Laser Marking Machine
PEDB-400B-带屏幕和传送带-1-1.jpg (52.24 KiB) Viewed 650 times
Post Reply