T2Laser controlling software-BRILLIANT!
Posted: Wed Dec 05, 2018 6:34 pm
Free to try, I was struggling to get my Chinese 2000mw laser to work at all with Benbox.. I downloaded this and it was quite intuitive.. the trial version allowed me 3 minutes of laser etching at a time, so I could give it a proper try on a small picture.. it initially went a bit awry, but then i found that it had firmware it could upload to my controller card, so I pushed that up and hey presto, my machine kicked into life and went like the proverbial off a shovel.. the only glitch I have to overcome now, is that it engraves a mirror image...
It does cost.. but at least you get to try it first, and at a one-off $39.95 the licence key arrived within a couple of hours (I think he generates them manually) and I am already 3 test etchings onto my trimmed plywood off cuts.. it's not a lot of money and has saved me many hours of frustration .
It does cost.. but at least you get to try it first, and at a one-off $39.95 the licence key arrived within a couple of hours (I think he generates them manually) and I am already 3 test etchings onto my trimmed plywood off cuts.. it's not a lot of money and has saved me many hours of frustration .