Optical fiber laser cutting machine down one of the biggest problems is the industrial computer internal temperature is too high!
In the environment of the high temperature operation for a long time, the computer's components easily happened ageing, hard disk failure frequency is higher than.Industrial computer the best temperature should be kept between 10 to 30 degrees c, too high, too low temperature protection of hard disk can cause a certain degree of influence, if the case reach 30 degrees Celsius temperature, the temperature of the internal hard drive will reach 40 degrees or higher.This will require a factory of CNC cutting machine operators, pay close attention to the case temperature.We also can undertake simple modification of industrial control, to reduce the industrial control the temperature of the working environment,the prospect of laser cutters for sale is very good.
(1), within the chassis mounted to the casing outside the convulsions of the fans, increasing air convection;
(2), placed in the industrial control cabinet, installation of small axial flow fan;
(3), in the control room equipped with air conditioning, in order to reduce the space temperature.
(4), replace the high power CPU, hard disk fan speed up heat dissipation.
Many laser cutting the manufacturer mostly need powder processing of raw materials, coupled with the outside world large air flow and a lot of dust, industrial PC within easy to accumulate a large amount of sticky dust, local high temperature caused by industrial PC, hardware damage.This kind of situation happens in CPU, power supply, hard disk, video card, such as a cooling fan around.Dust is lighter, in normal production permission, can use timing blowing dust.Can place with severe dust, industrial PC box placed drafty place strainer gauze, regular cleaning,the prospect of laser cutting machine for sale is very good.
Metal laser cutting machine cutting a burr how to solve
When we in the use of metal laser cutting machine, you must know that it not only promoted the development of social economy, on the other hand it also provides consumers with high quality goods.But in the use of the time we are going to have some related problems, like for processing sheet metal burr clearly how to solve?
Many customers in the metal laser cutting machine after completion of assembly, began to be put into use, and in the use of burr is very obvious, is this why?In this sharp laser suggested, after completion of the equipment assembly, need to debug for many times, can be put into use, it needs very professional laser equipment operation skills.
After the equipment cutting a burr:
1. The first thing to check whether the laser output is problematic, flare is very round
2. Review of laser transmission in the process of the lens is dirty, whether the lens with the naked eye is not easy to find tiny cracks, these will affect the transmission of laser power.
3. The above two check finished, to determine the laser itself is good, is after adjusting process parameters.Metal laser cutting equipment has certain hardness of burrs after cutting stainless steel, it is difficult to remove.Have to take, but also effect the beauty of the workpiece.The best solution on root.The purity of the gas, can be in a better quality of gas supplier, the purity of the gas is crucial, it is best not to use cylinders, because after two filling, purity is bad, also waste gases.Transferred to the best and the cutting parameters, focal length cutting speed air flow, after several adjustments, comes from the parameter of machine is cutting out exquisite artifacts.Adjust equipment + + gas parameters, to the best, cutting the workpiece is no burr,the prospect of laser cutter machine for sale is very good.
How to reduce the fiber laser cutting machine the probability of failure
Moderator: baker