Page 1 of 1

Help for k40 laser engraver/cutter

Posted: Thu Nov 05, 2015 3:36 am
by NEUPLENOEVEMI
Hello,

I am new in this engraving hobby and need a lot of help.
i started the engraving, but, after 10-20 seconds it is fading.

Please, see picture

also, what are the steps for engraving and cutting at the same time?
Step by step instructions please, since this is my first time.

Similar Threads:
Laser cutter/engraver
Need Help!- LASER ENGRAVER/CUTTER
Laser Cutter/Engraver
Why buy a Laser cutter when you can modify a laser engraver.

Attached Thumbnails

Re: Help for k40 laser engraver/cutter

Posted: Thu Nov 05, 2015 3:47 am
by Fbtbbhxep
Hello, you are new in this engraving hobby, you should ask your supplier for help, I think you can get good after sales service.

Re: Help for k40 laser engraver/cutter

Posted: Thu Nov 05, 2015 3:59 am
by Zfoebnhyk
Hello!You should learn more about how to use the laser machine.Perhaps you could find many videos on youtube, but I am not sure whether it can help you.Good luck to you.