Greetings! I joined the forum tonight.
I was exposed to lasers about four years ago and am in the final stages of deciding to buy a laser and start an engraving business.
I'm interested in finding a forum that discusses the pros and cons of the various laser manufacturers. I'm looking at Epilog and AP Laser products, but am open to others.
Can you point me to a forum like that?
I'd also be interested in talking to anyone who has been able to create a successful business with a laser machine.
Looking forward to reading lots of good posts!
New member
Moderator: baker
- Rob_Bottum
- Posts: 8
- Joined: Tue May 19, 2015 3:16 am
Re: New member
Which country are you come from?I'm Singapore.
What line of business are you in?& i could make handicrafts
What line of business are you in?& i could make handicrafts
-
- Posts: 2
- Joined: Thu Mar 24, 2016 11:49 pm
Re: New member
I'm in the United States, SE Wisconsin.
I'm making a late in life career change from banking to the engraving business.
I'm making a late in life career change from banking to the engraving business.
-
- Posts: 1
- Joined: Thu Apr 21, 2016 1:40 am
Re: New member
Hi everyone,
I just bought a laser machine from china. It is JQ 1390. I am not able to plug Chiller and Exhaust fan in to the machine, because the Power line's head is very different than machine's plug, is it Ok if I plug them in to separately to the Wall? Do I have to plug them in to machine? I need help. Let me know please.
I just bought a laser machine from china. It is JQ 1390. I am not able to plug Chiller and Exhaust fan in to the machine, because the Power line's head is very different than machine's plug, is it Ok if I plug them in to separately to the Wall? Do I have to plug them in to machine? I need help. Let me know please.
-
- Posts: 13
- Joined: Mon Apr 11, 2016 11:38 am
Re: New member
It should not matter from where they get the power.
The only thing would be the chiller.
If it is regulated by the controller you need to connect it there but if it has a temp setting you can use than again it does not matter from where the power comes.
You just need to make sure somehow that both are on when you use the machine.
The only thing would be the chiller.
If it is regulated by the controller you need to connect it there but if it has a temp setting you can use than again it does not matter from where the power comes.
You just need to make sure somehow that both are on when you use the machine.