Hi Guys,
I have a problem and maybe it is easy to fix ?
If i mark a line on wood with rdworks 40mm long, the laser only marks 37mm on the wood. If i test it with the x-ax it is 40mm long.
Is this a callibration issue ?
If i let the laser travel from top to bottom, the screen knows exactly what 0 to 700mm is. But somehow in a workflow it is out of allignment.
Anyone ?
y-ax size not correct
Moderator: baker
Re: y-ax size not correct
Please follow the pictures below to find the “Vender settings “and then input the password. Now select the X/Y axis and revise the step length, input the numbers as the below, and the software will count the correct number automatically, please click “save parameter “and then exit.
If not, please repeat the step 1-3.
You need a Ventor Parameter Password
Now reset the laser cutter and draw a new 100x100mm square, if the size is correct, the problem is fixed.If not, please repeat the step 1-3.
Re: y-ax size not correct
Hi Linus,
What ever i try, numbers are not changing.
Get stuck at 94mm
What ever i try, numbers are not changing.
Get stuck at 94mm
Re: y-ax size not correct
OK, calibrated 100% by hand, adjusted the step length x and y, tested a lot, and have _perfect_ 250x 250 and 100x100