compressed in y-axis

Discuss Laser Control Softwares here!

Moderator: baker

Post Reply
astronut
Posts: 1
Joined: Tue May 08, 2018 6:59 am

compressed in y-axis

Post by astronut » Tue May 08, 2018 7:08 am

I have a K40 (Chinese) engraver/cutter and am just starting to learn to use it. I have tried to run a photo image for engraving, using CorelDraw 12 with the CorelLaser plugin. It keeps compressing the y axis spread of the image - the x-axis is fine. I've looked through the settings but cannot find anything obvious that should be causing the issue...but I am missing something, no doubt.
Any suggestions gratefully received. Thanks.

Post Reply