Laser Engraver Forum

upload the source photo..
Mine laser has a lot better quallity but not good yet
mine engraves ok at 300mm/sec 33% power and it is 50w
look these
ruida+glass
https://www.youtube.com/watch?v=QD7A8XrRSC4
perhaps galvo
https://www.youtube.com/watch?v=jk6n1kB43YE

Very nice engraving futrelis, and I do like the galvo, just not an option at this point.
China has finally agreed it is not the tube or alignment. As of yet, they do not know what the problem is. I tried to scan a square with the interval set at 4.5 (yes 4.5)mm to see individual lines. The machine will only scan a solid square, yet the beam is small enough that I can cut a tiny line 1/2" into a piece of acrylic that is 1"x1"x 3/16" so it is not an alignment or focus problem.

look this is with glass tube on black marble with chinese leetro controller
https://www.youtube.com/watch?v=egEbdSWzA0g

Also i have uploaded a file ready to engrave (not needed to pass through photograv) on black granite/marble.
Set speed 300mm/sec, optimized scan, scan interval 0.1
and power make your tests.
This file engraves ok.
After engraving apply paint if you engrave on granite.

Thank you, I will give it a try. What power do you recommend for a 60w?

low for sure not more 35% try 25-30% for start

After using the SE for 1 month the hand grip is starting to shred anyone else noticed this ,anybody got a remedy for this poor quality sponge .