1.1 Introduction on Laser Carving and Cutting System
The laser carving and cutting system realizes the effective control to the laser numerically-controlled machine tool
through computer and complete the machining according to users’ different requirements. The system is
composed of control main board, control panel and supporting software. The instruction introduces how to use the
software to complete the laser machining task.
1.2 Support Plug-in
Drawing Software Operation System
Software Name Version WinXP Win7(32) Win7(64) Win8(64)
CorelDraw
Note: "√" indicates support, "X" indicates nonsupport and "?" indicates no test.
1.3 Format of Support File
(1) Vector Format: dxf, ai, plt, dst and dsb, etc.
(2) Bitmap Format: bmp, jpg, gif, png and mng, etc.
(3) Project File: pwj
1.4 Operating System Environment Requirements
(1) Operating system of WindowsXP or above.
(2) Above CPU586; PⅢ or above is recommended.
(3) The internal memory of over 1G is recommended.
Laser Carving and Cutting Software-Instruction for Operation
5
Chapter II Installation of Software
2.1 Install Drive
It shall be specially noticed that the drive program must be installed for the first installation. Otherwise, the
machine can’t be connected to!
(1) Double-click the setup.exe under the installation directory, and the following dialog box will appear:
(2) Click [Install the drive] and the following dialog box will appear:
(3) Click [Extract] and the following dialog will appear: ……
- contents2.png (57.83 KiB) Viewed 7153 times