hello
i have a kh5030 (white&blue chinese machine) 50 w tube( brand new) and 60w psu (brand new), ruida rdc6442g as controller
since i have changed the tube and psu i have an engraving issue
these marks are visible with naked eye only when i exeed 60mm/s in both x or y swing and uni
engraving problem
Moderator: baker
Re: engraving problem
Oh I see!Tolerances, offsets, and delays in the driver introduce an error that remains relatively fixed.You can try changes the setting Scan Mode: X_unilateralism
But you had another choice ,setting the system config
On this occasion, however, it had slowed down considerably.But you had another choice ,setting the system config
Because of major,be at ease so.
Re: engraving problem
Considering the Monport laser for its user-friendly interface, high quality, and affordability may help resolve the engraving issue you're experiencing with your KH5030 laser machine, equipped with a brand new 50W tube and 60W PSU, controlled by Ruida RDC6442G. If issues persist, contacting Monport's customer support or seeking advice from online forums could provide solutions tailored to your specific setup. https://monportlaser.com/collections/co ... ka374VZjm3