How to Improve Engraving Quality of Laser Machine

You can free download laser cut designs Free Vector Art from this forum.And you can Share your laser files, laser works here.

Moderator: baker

Forum rules
You need to do is register as a user and go directly to the files you want to Download
Post Reply
Cherry Stylecnc
Posts: 39
Joined: Mon Sep 04, 2017 7:44 am
Location: Jinan city, Shangdong province
Contact:

How to Improve Engraving Quality of Laser Machine

Post by Cherry Stylecnc » Thu Mar 29, 2018 10:08 am

If you want to improve engraving quality of your https://www.stylecnc.com/laser-engraving-machine/, try a simple setup procedure - adjust Reverse Interval.

Step 1: Initial Data

STYLECNC laser machine
Working area: 500x300 mm
Laser tube: 40 watts
Program: RD system

Step 2: Engraving Parameters

Run laser engraving program and draw small square with sides 10x10 mm.
Set engraving parameters
Processing Mode: Scan
Power (%): 30-40 (For 40 watt laser)
Speed (mm/s): 300
Interval (mm): 0.4 (This interval allows you to distinguish between engraved lines)
Engrave the image.
Look at the square with a magnifying glass. If even and odd lines do not dance and lines are aligned horizontally - then everything is fine. Otherwise, go to next step fot settings.

Step 3: System Setting

Open System Setting window: Config > System Setting > General Settings
Set Scanning (Reverse Interval) check box.
Add the following string values:
1.Speed (mm/s): 100 | Reverse Interval (mm): 0.10
2.Speed (mm/s): 200 | Reverse Interval (mm): 0.15
3.Speed (mm/s): 300 | Reverse Interval (mm): 0.19
4.Speed (mm/s): 400 | Reverse Interval (mm): 0.23
5.Speed (mm/s): 500 | Reverse Interval (mm): 0.25
6.Speed (mm/s): 600 | Reverse Interval (mm): 0.28
These values are valid for our particular machine instance. You may have other values.

Step 4: Square

If even lines (second line) are to the left of odd lines (first line), increase the value of Reverse Interval (Figure 1), otherwise reduce (Figure 2).
Adjust values for the Reverse Interval and engrave the square until the lines will align horizontally (Figure 3).
Do the same for all engraving speeds that you use.
Step 5: Vector Logo

Look at the quality of engraving of the vector logo:
1.Without adjustment Reverse Interval
2.With the correct setting Reverse Interval and the value of Interval (mm): 0.1
3.For better engraving, set the value to Interval (mm): 0.05
Step 6: Wood Luck!

Post Reply