If you want to improve engraving quality of your https://www.stylecnc.com/laser-engraving-machine/, try a simple setup procedure - adjust Reverse Interval.
Step 1: Initial Data
STYLECNC laser machine
Working area: 500x300 mm
Laser tube: 40 watts
Program: RD system
Step 2: Engraving Parameters
Run laser engraving program and draw small square with sides 10x10 mm.
Set engraving parameters
Processing Mode: Scan
Power (%): 30-40 (For 40 watt laser)
Speed (mm/s): 300
Interval (mm): 0.4 (This interval allows you to distinguish between engraved lines)
Engrave the image.
Look at the square with a magnifying glass. If even and odd lines do not dance and lines are aligned horizontally - then everything is fine. Otherwise, go to next step fot settings.
Step 3: System Setting
Open System Setting window: Config > System Setting > General Settings
Set Scanning (Reverse Interval) check box.
Add the following string values:
1.Speed (mm/s): 100 | Reverse Interval (mm): 0.10
2.Speed (mm/s): 200 | Reverse Interval (mm): 0.15
3.Speed (mm/s): 300 | Reverse Interval (mm): 0.19
4.Speed (mm/s): 400 | Reverse Interval (mm): 0.23
5.Speed (mm/s): 500 | Reverse Interval (mm): 0.25
6.Speed (mm/s): 600 | Reverse Interval (mm): 0.28
These values are valid for our particular machine instance. You may have other values.
Step 4: Square
If even lines (second line) are to the left of odd lines (first line), increase the value of Reverse Interval (Figure 1), otherwise reduce (Figure 2).
Adjust values for the Reverse Interval and engrave the square until the lines will align horizontally (Figure 3).
Do the same for all engraving speeds that you use.
Step 5: Vector Logo
Look at the quality of engraving of the vector logo:
1.Without adjustment Reverse Interval
2.With the correct setting Reverse Interval and the value of Interval (mm): 0.1
3.For better engraving, set the value to Interval (mm): 0.05
Step 6: Wood Luck!
How to Improve Engraving Quality of Laser Machine
Moderator: baker
Forum rules
You need to do is register as a user and go directly to the files you want to Download
You need to do is register as a user and go directly to the files you want to Download
-
- Posts: 44
- Joined: Mon Sep 04, 2017 7:44 am
- Contact:
-
- Posts: 1
- Joined: Thu Dec 13, 2018 8:23 am
Re: How to Improve Engraving Quality of Laser Machine
Very good post. Lots of information mentioned in this article. Thanks for sharing here.
Total ankle replacement surgeon in New Jersey I Orthopedic dr in NJ
Total ankle replacement surgeon in New Jersey I Orthopedic dr in NJ