Fume Extraction

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder Laser -Nolan, Thunder laser - Tom

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
Rayden
Posts: 3
Joined: Thu Feb 01, 2018 5:53 am
Location: Canada

Fume Extraction

Post by Rayden » Sat Sep 08, 2018 5:50 am

I have noticed that during cutting the 4 small fans, on each side of the machine (that are for cooling the electronics), are blowing laser fumes out into my room. I am wondering if that is the correct direction for them to be blowing (out rather than in).

Also, would it hurt anything if I turned them around so they blow inwards, towards the electronics.

Thank you

Thunder laser - Tom
Posts: 104
Joined: Fri Jun 05, 2015 8:16 am

Re: Fume Extraction

Post by Thunder laser - Tom » Mon Sep 10, 2018 1:15 am

That's no problem.

Post Reply