Just loaded the new V8.01.24 and now I have a new problem.
The object looks fine on the computer and on the laser screen after downloaded. When I "Frame" the job, the frame path of the laser head is extremely different. Not even close to reality.
I am also getting regular "X slop over" messages which I can't get past using previous methods.
Thanks, JIM
V8.01.24 Drastic size change between screen and laser
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
V8.01.24 Drastic size change between screen and laser
ThunderLaser Nova35 100w
RDWorks V 8.01.24
Santa Barbara, California
RDWorks V 8.01.24
Santa Barbara, California