Page 2 of 2

Re: Cutting Problem

Posted: Fri Sep 22, 2017 1:43 am
by Ben
Hi Steven,

The amp circuit is determined by the machine loading.
It's enough for the start up.
I think that the problem should not happen from the very beginning.
And yes,there is some sort of power problem with the laser when the laser, air compress and the blower come on at the same time.
But even the electrical should not affect the control signal to the laser power supply,because there's an isolator to separate the interference.
111.png
111.png (171.83 KiB) Viewed 2497 times

Re: Cutting Problem

Posted: Fri Sep 22, 2017 9:23 am
by Ben
Hi Steven,

There is a solution for you.
You can use the laser through mode,set the Open Delay,then the machine will laser on the Through power during the Open Delay time without laser head movement.
laser head will move with the working power until the Open Delay time is up.
Set back the TL-timer to Auto mode then try with that.
11.png
11.png (26.44 KiB) Viewed 2487 times

Re: Cutting Problem

Posted: Tue Sep 26, 2017 12:28 am
by stevenresnick
Hi Ben
I tried what you had recommended and the results are the
same.
It works fine when in the manual mode.
Could a part gone bad???

Thanks
Steven