Welcome to laserengraverforum.com!

Impossible to connect thru ethernet

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder Laser -Nolan, Thunder laser - Tom

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
Andy
Posts: 16
Joined: Thu Mar 03, 2016 2:18 pm

Impossible to connect thru ethernet

Post by Andy » Thu Nov 16, 2017 2:13 pm

I had a problem with my computer, so i had to reinstall RD Vision on a new computer.
The problem is that now, i cannot connect anymore to my Mars Lasercut machine.
The message is 'communication failure' but the adress is 192.168.1.100 (the same as in the system config in the machine)...
Anybody to help me? I am blocked in my production and it's very urgent for me ;-(
Thank you by advance...

Andy
Posts: 16
Joined: Thu Mar 03, 2016 2:18 pm

Re: Impossible to connect thru ethernet

Post by Andy » Thu Nov 16, 2017 4:00 pm

...and i use Windows 8.1 on this computer...

Andy
Posts: 16
Joined: Thu Mar 03, 2016 2:18 pm

Re: Impossible to connect thru ethernet

Post by Andy » Tue Nov 21, 2017 9:50 am

The problem was that the number IP of the PC was in another range then the laser cutter…
I had to change the range in the laser cutter to meet the same PC numbers, leaving only a difference on the last number.
In this case the pc was 169.254.181.59, i had to give the address 169.254.181.100 to the machine and it works perfectly well now.

Post Reply