Page 1 of 1

Impossible to connect thru ethernet

Posted: Thu Nov 16, 2017 2:13 pm
by Andy
I had a problem with my computer, so i had to reinstall RD Vision on a new computer.
The problem is that now, i cannot connect anymore to my Mars Lasercut machine.
The message is 'communication failure' but the adress is 192.168.1.100 (the same as in the system config in the machine)...
Anybody to help me? I am blocked in my production and it's very urgent for me ;-(
Thank you by advance...

Re: Impossible to connect thru ethernet

Posted: Thu Nov 16, 2017 4:00 pm
by Andy
...and i use Windows 8.1 on this computer...

Re: Impossible to connect thru ethernet

Posted: Tue Nov 21, 2017 9:50 am
by Andy
The problem was that the number IP of the PC was in another range then the laser cutter…
I had to change the range in the laser cutter to meet the same PC numbers, leaving only a difference on the last number.
In this case the pc was 169.254.181.59, i had to give the address 169.254.181.100 to the machine and it works perfectly well now.