Page 1 of 1

Mars90 Y axe problem

Posted: Thu Jan 04, 2018 11:24 pm
by Alexandre
Hi Tom

I do have a Mars90_130 watts

it seems i do have a mecanical problem with the Y axe.
see picture...look like it jump lines
Job: engraving glass with transfert tape over the glass, speed 500 power 25
Already did couple glass without problems ...than... that happen.
20180104_173458.jpg
20180104_173458.jpg (147.38 KiB) Viewed 5009 times
-Belt tension is ok
-ear a new noise from the machine... seems to be close to the Y motor rotary belt and gear

I'm stock on a client job!
waiting for your reply

Best regards

ALX

Re: Mars90 Y axe problem

Posted: Sat Jan 06, 2018 1:20 am
by Ben
Hi ALX,

Sorry to hear that your machine is not working well.
From your description,and yes,it seems be to the mechanical problem with the Y aixs.
Both sides belt tension are ok for Y,but noise close to the Y motor.please have a look to the below link.
I think that maybe the belt of Y motor that becomes loose,it would better to check and adjust for it.
To fix the noise (http://www.thunderlaser.com/troubleshoo ... rhead.html).
To adjust the belt tension of Y motor (http://www.thunderlaser.com/troubleshoo ... motor.html)
Any news just let me know,hope your machine back to work soon.