Mars90 Y axe problem
Posted: Thu Jan 04, 2018 11:24 pm
Hi Tom
I do have a Mars90_130 watts
it seems i do have a mecanical problem with the Y axe.
see picture...look like it jump lines
Job: engraving glass with transfert tape over the glass, speed 500 power 25
Already did couple glass without problems ...than... that happen. -Belt tension is ok
-ear a new noise from the machine... seems to be close to the Y motor rotary belt and gear
I'm stock on a client job!
waiting for your reply
Best regards
ALX
I do have a Mars90_130 watts
it seems i do have a mecanical problem with the Y axe.
see picture...look like it jump lines
Job: engraving glass with transfert tape over the glass, speed 500 power 25
Already did couple glass without problems ...than... that happen. -Belt tension is ok
-ear a new noise from the machine... seems to be close to the Y motor rotary belt and gear
I'm stock on a client job!
waiting for your reply
Best regards
ALX