Page 1 of 1
RD Works
Posted: Sat Jan 06, 2018 3:08 pm
by Salmagundi
HOw do I program RD Works to perform two runs for cutting? I've tried just copying and pasting the cut line on top of the original cut line, but when I paste, the image does not paste directly onto the original, it pastes somewhere else and then I can't move it to exactly where I want it to paste, i.e. directly on to of the original.
Thanks for any help or suggestions
Re: RD Works
Posted: Fri Jan 12, 2018 2:35 am
by Ben
Hi Salmagundi,
There are two ways can meet your need.
1.Copy and paste,then how to move onto the original,below tools will help you.
- location tool.png (47.26 KiB) Viewed 9223 times
2.Enable feeding,only change the value of the "Count",then the whole files will perform as you set.
- Enable feeding.png (8.23 KiB) Viewed 9223 times
Re: RD Works
Posted: Sun Jan 14, 2018 3:17 pm
by Salmagundi
thank you Ben. I kind of figured it out using the first method.