Problems with setting for rotary axis

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
User avatar
Jonpeder
Posts: 3
Joined: Wed Dec 20, 2017 4:19 pm

Problems with setting for rotary axis

Post by Jonpeder »

The image comes out all wrong when I'm trying to engrave on a glass.

The diameter on the glass is 81 mm. Please look at the pictures with my settings.

When I write 81 mm diameter the engraving is very compact. Look at Image 1.

Look also at image 4, where you see that the image is supposed to have 112 mm height. But when I push the preview it says 55,7 mm height. Look at image 5

What am I doing wrong?

Any help will be appreciated:)
Attachments
Image 4.jpg
Image 4.jpg (95.86 KiB) Viewed 6619 times
image 1.jpg
image 1.jpg (76.39 KiB) Viewed 6619 times
20180113_125010 1.jpg
20180113_125010 1.jpg (73.96 KiB) Viewed 6619 times
20180113_125000.jpg
20180113_125000.jpg (83.52 KiB) Viewed 6619 times
Ben
Posts: 137
Joined: Tue May 24, 2016 9:06 am

Re: Problems with setting for rotary axis

Post by Ben »

Hi Jon,

This is Ben from Thunderlaser.
About your problem,
1.the setting for software is alright.
setting for rotary attachment.png
setting for rotary attachment.png (10.56 KiB) Viewed 5753 times
Select “Output”, and then tick“Enable rotate engrave”
① The Circle pulse is set to 16000 (Please set circle pulse to 7601 while your machine is bought before February 2016, Not including Feb 2016)
② The diameter of the target item
2.the setting for rotary attachment.
setting of motor of rotary attachment.jpg
setting of motor of rotary attachment.jpg (200.61 KiB) Viewed 5753 times
Number 1-6:on off on off on off.
please check them and test again.
User avatar
Jonpeder
Posts: 3
Joined: Wed Dec 20, 2017 4:19 pm

Re: Problems with setting for rotary axis

Post by Jonpeder »

Hi!

I think that worked. Button number 3 was in wrong position for some reason. Thanks:)
Post Reply