Page 1 of 1

Problems with setting for rotary axis

Posted: Wed Jan 17, 2018 11:04 am
by Jonpeder
The image comes out all wrong when I'm trying to engrave on a glass.

The diameter on the glass is 81 mm. Please look at the pictures with my settings.

When I write 81 mm diameter the engraving is very compact. Look at Image 1.

Look also at image 4, where you see that the image is supposed to have 112 mm height. But when I push the preview it says 55,7 mm height. Look at image 5

What am I doing wrong?

Any help will be appreciated:)

Re: Problems with setting for rotary axis

Posted: Thu Jan 18, 2018 10:18 am
by Ben
Hi Jon,

This is Ben from Thunderlaser.
About your problem,
1.the setting for software is alright.
setting for rotary attachment.png
setting for rotary attachment.png (10.56 KiB) Viewed 5774 times
Select “Output”, and then tick“Enable rotate engrave”
① The Circle pulse is set to 16000 (Please set circle pulse to 7601 while your machine is bought before February 2016, Not including Feb 2016)
② The diameter of the target item
2.the setting for rotary attachment.
setting of motor of rotary attachment.jpg
setting of motor of rotary attachment.jpg (200.61 KiB) Viewed 5774 times
Number 1-6:on off on off on off.
please check them and test again.

Re: Problems with setting for rotary axis

Posted: Tue Jan 23, 2018 9:04 pm
by Jonpeder
Hi!

I think that worked. Button number 3 was in wrong position for some reason. Thanks:)