Laser Engraver Forum

Hello

I have a problem with engraving on X-axis - laser Nova24 60 Watt
Engraving is very low quality (please see photos in the attachment) For engraving we use the following settings: Scan mode, 400 mm/s speed, 15 power and interval 0,08mm. This problem occurs on each material.
But when engraving on Y-axis the engraving is good quality
Earlier there was no problem with the quality of the engraver on X-axis .

What can be a problem ?
I am asking for help and instructions how to solve the problem?
I will be gratefull for any answer.

Regards
marek-xx

Hi Marek,

Engraving on X aixs is very low quality,but on Y axis is good quality.right?
For engraving problem,please first to check as following:
If engraving on Y axis is alright,so the focus lens should be well,but i recommend you take it out to clean after using every day.
Then check the driver belt of X axis,make sure it's taut and not became slack.

Hi Jason

Yes, engraving on Y axis is good quality.
Focus lens is clean .
Which X axis drive belt should I check and how to tension it?
Can you send the instructions?

Hi Marek,

For engraving on X axis,what kind of scan mode you set? X-unilateralism or X-swing?
Did you try X-unilateralism,how about the result.

To adjust the X axis blet,please see below.just make sure it's taut. (① fix the belt; ②adjust the tension of the belt;)