Hello
I have a problem with engraving on X-axis - laser Nova24 60 Watt
Engraving is very low quality (please see photos in the attachment)
For engraving we use the following settings: Scan mode, 400 mm/s speed, 15 power and interval 0,08mm. This problem occurs on each material.
But when engraving on Y-axis the engraving is good quality
Earlier there was no problem with the quality of the engraver on X-axis .
What can be a problem ?
I am asking for help and instructions how to solve the problem?
I will be gratefull for any answer.
Regards
marek-xx
Nova24 engraving problem on X-Axis
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Re: Nova24 engraving problem on X-Axis
Hi Marek,
Engraving on X aixs is very low quality,but on Y axis is good quality.right?
For engraving problem,please first to check as following:
If engraving on Y axis is alright,so the focus lens should be well,but i recommend you take it out to clean after using every day.
Then check the driver belt of X axis,make sure it's taut and not became slack.
Engraving on X aixs is very low quality,but on Y axis is good quality.right?
For engraving problem,please first to check as following:
If engraving on Y axis is alright,so the focus lens should be well,but i recommend you take it out to clean after using every day.
Then check the driver belt of X axis,make sure it's taut and not became slack.
Re: Nova24 engraving problem on X-Axis
Hi Jason
Yes, engraving on Y axis is good quality.
Focus lens is clean .
Which X axis drive belt should I check and how to tension it?
Can you send the instructions?
Yes, engraving on Y axis is good quality.
Focus lens is clean .
Which X axis drive belt should I check and how to tension it?
Can you send the instructions?
Re: Nova24 engraving problem on X-Axis
Hi Marek,
For engraving on X axis,what kind of scan mode you set? X-unilateralism or X-swing?
Did you try X-unilateralism,how about the result.
To adjust the X axis blet,please see below.just make sure it's taut. (① fix the belt; ②adjust the tension of the belt;)
For engraving on X axis,what kind of scan mode you set? X-unilateralism or X-swing?
Did you try X-unilateralism,how about the result.
To adjust the X axis blet,please see below.just make sure it's taut. (① fix the belt; ②adjust the tension of the belt;)