Pulse button
Posted: Thu Mar 22, 2018 9:49 pm
Hi Ben,
I have to cut a cardboard only half of its thickness and I was playing around and get very good results using the pulse button.
In few passes the cardboard was half cut and the cuts were extremely clean, no trace of burn at all.
# Is it OK to use the pulse function for this type of job? ( I have to half cut cardboard for about 100 packaging boxes)
# is there a way to set this procedure from rdworks software?
Thank you
Anda
I have to cut a cardboard only half of its thickness and I was playing around and get very good results using the pulse button.
In few passes the cardboard was half cut and the cuts were extremely clean, no trace of burn at all.
# Is it OK to use the pulse function for this type of job? ( I have to half cut cardboard for about 100 packaging boxes)
# is there a way to set this procedure from rdworks software?
Thank you
Anda