Edit startingpoint of cutting

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
User avatar
StefanV
Posts: 8
Joined: Fri Oct 20, 2017 9:21 am

Edit startingpoint of cutting

Post by StefanV »

How do you set the starting point for a cut job?
I want the job to start at a different point from where it normally start


RDWorks V8 with a Mars 90 - 100Watt
Ben
Posts: 137
Joined: Tue May 24, 2016 9:06 am

Re: Edit startingpoint of cutting

Post by Ben »

Generally,it's left top corner.
Startpoint for the graphic.png
Startpoint for the graphic.png (90.64 KiB) Viewed 10586 times
Post Reply