thin metal cut 05 mm / 0.7 mm

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
User avatar
andaluzia1973
Posts: 22
Joined: Wed Jul 05, 2017 11:50 am

thin metal cut 05 mm / 0.7 mm

Post by andaluzia1973 »

Hi

I would like to attempt to cut a thin metal 0.5 mm / 0.7 mm.
What are the measure of protection that I have to take in order to prevent damages on the machine?
What are the setting to start with (130W laser)?

Thank you
Anda
User avatar
Wayne
Posts: 14
Joined: Thu Oct 15, 2015 1:55 am

Re: thin metal cut 05 mm / 0.7 mm

Post by Wayne »

if it is a good tube which is outputting more than 130W you will cut thin mild steel upto half a mm, but it will be slow 1 -2mm per sec.

To cut metal you really need 150+W and Oxygen not air, although there is oxgen in air its only around 20 percent, pure oxygen acts like fuel and reacts with the heated metal to increase the temperature, this enables the machine to cut faster, with Oxy and 130W you may get upto 5mm sec, but it really depends on the output of the tube. around 95PSI is good for cutting, but your laser may not be equiped to deal with such high pressures. Most laser air assist is less than 1 bar
Post Reply