Scan/Engrave Direction

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
Rayden
Posts: 4
Joined: Thu Feb 01, 2018 5:53 am

Scan/Engrave Direction

Post by Rayden »

Hello, I am looking for a way to change my scan/engrave direction to- bottom to top (for example, if it was an image of a person, I would want to start engraving at the feet and work my way up to the head). I am not sure if this is done in RDWorks or via the machine. Thank you.
Ben
Posts: 137
Joined: Tue May 24, 2016 9:06 am

Re: Scan/Engrave Direction

Post by Ben »

Hi Rayden,

It can be done by rdworks.
From menu bar,config>>system setting.
123.png
123.png (22.33 KiB) Viewed 8956 times
Post Reply