Page 1 of 1

Fume Extraction

Posted: Sat Sep 08, 2018 5:50 am
by Rayden
I have noticed that during cutting the 4 small fans, on each side of the machine (that are for cooling the electronics), are blowing laser fumes out into my room. I am wondering if that is the correct direction for them to be blowing (out rather than in).

Also, would it hurt anything if I turned them around so they blow inwards, towards the electronics.

Thank you

Re: Fume Extraction

Posted: Mon Sep 10, 2018 1:15 am
by Thunder laser - Tom
That's no problem.