Turn on fan/blower and air compressor?

[Jasper_Rullman]

How can I turn on the fan/blower and air compressor?
When I turn on the Mars130 laser no power is sent to the fan/blower and air compressor.

Thank You.

[Thunder laser - Tom]

Hi Jasper
This is Tom from thunder laser
When you press start a job, the laser will turn on the fan and air compressor immediately
The laser send a work signal to a mainboard(TL-Timer) to asking output power to exhaust fan and air compressor
And when the job is finished, both device will be stopped after 5 seconds delay(for air compressor) and 15 seconds delay(for exhaust fan)
Their delay time can be change by a little mainboard that called TL-Timer are made by Thunder laser
Please try to send a file and start the job to see if they are work then

Have a good night

Best Regards

Tom

[Jasper_Rullman]

Hi Jasper
This is Tom from thunder laser
When you press start a job, the laser will turn on the fan and air compressor immediately
The laser send a work signal to a mainboard(TL-Timer) to asking output power to exhaust fan and air compressor
And when the job is finished, both device will be stopped after 5 seconds delay(for air compressor) and 15 seconds delay(for exhaust fan)
Their delay time can be change by a little mainboard that called TL-Timer are made by Thunder laser
Please try to send a file and start the job to see if they are work then

Have a good night

Best Regards

Tom

I just solved it.
Thanks!

All the Best,
Khristian Bombeck

[Thunder laser - Tom]

Hi Khristian
Good job
Any unclear, please contact with us again

Have a nice dream

Best Regards

Tom